|
|
Toyota's Service Schedule for the Supra. Services go A B A C A B A C etc. with a service happening every 6,000 miles or 6 months whichever is the sooner. So an A service is a 6,000 mile service, B is 12,000 and C is 24,000. SERVICE SCHEDULE "A" Change engine oil - inspect for leakage Replace engine oil filter Check engine coolant level and strength Check exhaust system and mountings for security and leakage Inspect drive belts for wear and deflection Check spark plugs - replace if necessary (Platinum tipped spark plugs only every 60,000 miles) Inspect CB points, replace if necessary (as applicable) Check battery electrolyte levels, and terminals for security Check brake and clutch fluid levels Check brake and clutch pedal free play and parking brake travel Check and report on brake pads Check brake and clutch system pipes, hoses and connections for leakage Check heater and cooling system, oil cooler and all fuel pipes, hoses and connections for leakage Check transmission, differential and steering for oil leakage and report Lubricate propeller shaft grease points (as applicable) Check all electrical systems for correct operation Check all lights for damage, correct operation and alignment Check windscreen wipers/washers for correct operation/direction and top up washer fluid level Check tyre condition and inflation pressures Check torque of road wheel nuts Inspect bodywork for any abrasions or damage which, if left unattended, may lead to corrosion - Report to owner Lubricate door hinges, key and lock mechanisms, including fuel filler door Check seat belts front and rear for correct operation, condition of webbing and security anchorage points Road test and report 'CHECK' means check and adjust or top up SERVICE SCHEDULE "B" Check valve clearances (extra charge for adjustment on DOHC engines) Inspect drive belts for wear and deflection Change engine oil - inspect for leakage Replace engine oil filter Inspect cooling and heater system hoses and connections for leakage Inspect oil cooler hoses and connections (as applicable) Inspect exhaust system and mountings for security and leakage Check engine coolant level and strength Replace spark plugs (Platinum tipped spark plugs only every 60,000 miles) Replace CB points and inspect rotor (as applicable) Check ignition timing, dwell angle and advance operation Check battery electrolyte levels, and terminals for security Clean air filter element Check engine idle speed, CO emission and choke operation Inspect fuel tank cap, fuel lines and connections Inspect fuel vapour check valve Check throttle positioner/dash pot (throttle damper setting/speed) Inspect exhaust gas recirculation system (EGR) and charcoal canister (as applicable) Check clutch fluid level Check brake and clutch pedal free play and parking brake travel Check and report on brake pads, discs, linings and drums, clean out dust Re-pack rear wheel bearings with grease (Starlet only) Inspect air injection system or air suction system (2Y, 3Y, 4Y only) Check level and condition of brake fluid - top up or replace if necessary (extra charge for replacement) Check brake and clutch system pipes, hoses and connections Check steering wheel free play and linkage for wear and security, including front wheel tracking (extra charge for adjustment) Inspect ball joints and dust covers Inspect drive shaft dust covers (as applicable) Check differential oil - inspect for leakage Check transmission oil - inspect for leakage Check transfer box oil (as applicable) - inspect for leakage Check steering box oil level and PAS fluid level (as applicable) - inspect for leakage Lubricate propeller shaft grease points (as applicable) Inspect front and rear suspension for correct operation and security Grease all steering joints, linkages and suspension bushes (as applicable) Check all electrical systems for correct operation Check all lights for damage, correct operation and alignment Check windscreen wipers/washers for correct operation/direction and top up washer fluid level Check tyre condition, inflation pressures and report Check torque of road wheel nuts Inspect bodywork for any abrasions or damage which, if left unattended may lead to corrosion - Report to owner Lubricate door hinges, key and lock mechanisms, including fuel filler door Check seat belts front and rear for correct operation, condition of webbing and security of anchorage points Road test and report 'CHECK' means check and adjust or top up SERVICE SCHEDULE "C" Check valve clearances (extra charge for adjustment on DOHC engines) Inspect drive belts for wear and deflection Change engine oil - inspect for leakage Replace engine oil filter Inspect cooling and heater system hoses and connections for leakage Inspect oil cooler hoses and connections (as applicable) Check engine coolant level and strength. Replace at 48,000 mile intervals Inspect exhaust system and mountings for security and leakage Replace spark plugs (Platinum tipped spark plugs only every 60,000 miles) Replace CB points and inspect rotor (as applicable) Check ignition timing, dwell angle and advance operation Check battery electrolyte levels and terminals for security. Replace fuel filter Replace air filter element Check engine idle speed, CO emission and choke operation Inspect fuel tank cap, fuel lines and connections for leakage Inspect fuel vapour check valve Check throttle positioner/dash pot (throttle damper setting/speed). Inspect exhaust gas recirculation system (EGR) and charcoal canister (as applicable) Check level and condition of brake fluid - top up or replace if necessary (extra charge for replacement) Check clutch fluid level Check brake and clutch pedal free play and parking brake travel Check and report on brake pads discs linings and drums, clean out dust Inspect air injection system or air suction system (2Y, 3Y, 4Y only). Check brake and clutch system pipes, hoses and connections for leakage. Re-pack front wheel hearings with grease (commercial vehicles only) Check steering wheel free play and linkage for wear and security, including front wheel tracking (extra charge for adjustment) Inspect ball joints and dust covers Inspect drive shaft dust covers (as applicable) Change differential oil - inspect for leakage Change transmission oil - inspect for leakage Change transfer box oil (as applicable) - inspect for leakage Check steering box oil level and PAS fluid level (as applicable) - inspect for leakage. Lubricate propeller shaft grease points (as applicable) Inspect front and rear suspension for correct operation and security. Grease all steering joints, linkages and suspension bushes (as applicable) Tighten bolts on chassis and body Check all electrical systems for correct operation. Check all lights for damage, correct operation and alignment. Check windscreen wipers/washers for correct operation/direction and top up washer fluid level Check tyre condition and inflation pressures and report Check torque of road wheel nuts Inspect bodywork for any abrasions or damage which, if left unattended, may lead to corrosion - Report to owner. Lubricate door hinges, key and lock mechanisms, including fuel filler door. Check seat belts front and rear for correct operation, condition of webbing and security of anchorage points. Road test and report 'CHECK' means check and adjust or top up |